Service Pipe Entry Seals (top hats) Radon - Cavity TraysService Pipe Entry Seals (top hats) Radon - Cavity Trays

Service Pipe Entry Seals (top hats)

  • Seal around pipe, sleeve and duct penetrations.
  • Sizes to suit pipes of 55mm and 110mm.
  • Black polypropylene.
  • For use with compatible bonding tape/jubilee clip

USE
Preformed Service Pipe Entry Seals (often termed ‘top hats’) are available in a range of sizes. They provide effective protection against damp and gas ingress around the service pipe penetration. Manufactured from black gas grade rigid polypropylene, the base of each entry point is secured to the dry membrane penetration area utilising bonding strip on and around the underside of the base. The rising sleeve snugly fits the pipe dimension and is secured utilising bonding strip and tightening clamp.

Description

Preformed Service Pipe Entry Seals (often termed ‘top hats’) are available in a range of sizes. They provide effective protection against damp and gas ingress around the service pipe penetration. Manufactured from black gas grade rigid polypropylene, the base of each entry point is secured to the dry membrane penetration area utilising bonding strip on and around the underside of the base. The rising sleeve snugly fits the pipe dimension and is secured utilising bonding strip and tightening clamp.

Where penetrations of the gas-grade oversite membrane are not addressed using standard sized Service Pipe Entry Points, bespoke options are available with collars designed to receive round and rectangular projections of all dimensions. Your requirements can be determined if you make use of our free design and advisory service.

Downloads and Documents

Datasheet PDF82.07 KB Download file

View all resources

Need help?

Our experts are on hand to advise you about any of our cavity tray products.

Call 01935 474769

Where to buy

Our cavity trays are available from suppliers up and down the country.

Find a local SUPPLIER